Elna International Corps. SA
Xquist
service manual
cam.
•
Top end section of the main shaft disengaging
stopper.
MAIN MOTOR
MAIN MOTOR.
1. Remove the Under Cover.
2. Remove the Belt Cover.
3. Remove the Free arm bottom cover.
4. Loosen the 5 screws from the bottom plate
base.
5. Remove the Rear Cover (see below).
MAIN MOTOR.
1. Remove the screw 1
situation of this screw
.
Turn the hand wheel so that the needle bar is in
lowest position (this screw fixe the rear cover
and is to reach from the front inside over the
take up lever).
MAIN MOTOR.
1. Remove the two screws 1
2. Remove the two screws 3
3. Remove the screw 4.
4. Lower the presser bar 5.
5. Lift the handle 6, draw section 7 and remove
the rear panel.
6. Remove claw section 8 with the under cover.
