7
Machine
FAQ
A7-2
The bobbin thread broke.
Check the following. Replace the bobbin thread and restart sewing.
Q8.
The thread is getting tangled on the wrong side of the fabric.
A8
Follow steps below to remove the tangled thread.
Stop the embroidery machine. Turn the power switch OFF.
Raise the presser foot lifter and the needle. Cut the tangled thread on the
wrong side of the fabric.
Do not turn the handwheel forcibly if it does not rotate.
Contact the store from which the machine was purchased.
Remove the hoop from the machine.
Remove the needle plate(Refer to the instruction manual “Cleaning the
Hook Area).
Remove the bobbin holder and remove the tangled thread.
Attach the bobbin holder and the needle plate.
Thread the needle thread and bobbin thread to the machine.
Refer to Q15 to resume sewing
Q9
I cannot attach a fabric to a hoop well.
A9
You cannot attach a thick or hard fabric to the hoop. (The thickness of the fab-
ric should be 0.2 cm (1/12”) or less.)
Float the fabric if the fabric is too fine to attach (Refer to Embroidery
FAQ Q3-9).
