The function layout is shown below. Short operation means holding for about 1 sec. Long operation means holding for 2
sec or longer.
Extended function control (channel 5)
If channel 5 is equipped with a knob or slider control, the number of available user
sounds is increased. There are two additional function levels for the half down position
(user sounds level 2) and half up position (user sounds level 3). Thus, a total of 24 user
sounds are possible.
Vehicle control using a computer or Android
®
The
ElMod Fusion Puma
can be controlled via a Windows
®
or Apple
®
computer or
Android
®
smartphone/tablet. For this purpose the optionally available
ElMod Bluetooth
is
required, which has to be attached to
connector 7
.
The computer control remains deactivated as long as connector 8 (receiver) is left empty.
Parallel operation with a proportional receiver is not possible.
Status LEDs
The blue and red status LEDs on the PCB show the current operating status of the
ElMod Fusion Puma
.
off
on
ready to operate. blue LED blinks once after stick movement
off
blinking no receiver signal detected
on
off
under- or overvoltage protection active
on
on
no SD card inserted, card empty or its contents faulty (operation with default settings and without
sound only)
Installation
When selecting the installation location, the following must be observed:
•
Make sure that short circuits are excluded. No live parts may touch each other. It is best to insulate all open cable
connections with a piece of heat shrinkable tubing.
•
Keep current-carrying cables, especially the supply lines to the drive motors and drive battery as short as possible to
minimize interference.
•
Ensure that the receiver's antenna is not located within shielded metal walls (e.g. in the hull of a vehicle) or between
power consumers (motors). This can lead to drastic deterioration of the radio signal, loss of radio communication and
- 8 - © ElMod - 19-12-26
