to connection 10 accordingly (terminals "Fan" to the fan, terminals "Heat" to the heater).
The polarity (plus/minus) is printed next to the connections on the board
Turret and weapon functions
•
Turret motor: connect the turret motor to
connector 1
. If the turret motor runs in the wrong direction, turn the plug
around.
•
Gun elevation: connect the servo for raising/lowering of the main gun to the
connector for servo 2
. For further details
see the section "Servos".
•
Gun recoil: the gun recoil retraction simulation is also performed using a servo. This is connected to the
servo 3
connector
. Refer to the "Servos" section for further details.
Light functions
The
ElMod Fusion Puma
can control different light channels:
•
Machine gun muzzle flash.
Connector 2, MG
is for the muzzle flash of an optional MG. An LED
(preferably super bright, white or red) can be connected directly to it.
•
Front lighting (
connection 2. L1
). One or two white LEDs.
•
Stealth light (
connection 2. L2
). One or two white LEDs.
•
Combined rear and brake light (
connection 2, L3
). One or two red LEDs. This light is switched
together with the main light. The brake light also comes on when the main light is switched off
during braking.
•
Muzzle flash: The Taigen
®
xenon flash or the HengLong
®
muzzle flash is supported. These are equipped with a 5-pin
plug and are connected to
connection 3
.
All light connections are protected against short circuit and overload. The anode of the LEDs is connected to the
respective left pin, the cathode to the right.
Loudspeaker and volume control
•
Connect the supplied volume control to the provided
connector 5
.
•
The
ElMod Fusion Puma
offers the option to control the overall volume
via channel 6 on the transmitter. If this is desired, the corresponding
parameter must be set in the
ElMod App
(tab "Sound Volume",
parameter "Main Volume control" to "external"). In this case the
connection 5
can remain empty.
•
Solder the speaker cable to a suitable 8 Ohm speaker and connect it to
the speaker output (
connector 6
). The speaker polarity (+/-) is irrelevant.
•
Connect a fully charged battery to the
ElMod Fusion Puma
and wait 3-4 seconds until the blue LED starts flashing
regularly.
•
Now briefly tap the setup button. From the loudspeaker you hear the announcement "Battle Mode...". Tap the button
repeatedly until "Battle Mode off" is heard.
•
If you don’t hear anything, check whether the volume is set too low.
- 3 - © ElMod - 19-12-26
