Elma 46
23
v. 170309
5. Setup Selections
5.1 Select length measurement units between feet ( ft ) and meters (m).
1. Turn off the tester, press and hold down SET key, then press and hold down power key,
until display show LENGTH UNIT.
2. Press ▼or ▲ keys to the desired length units.
3. Press SET key to store the units and exit this mode.
5.2 Setup items:
The setup mode allows to select and calibrate cable characteristics.
Once changed, these settings are stored and remain in the tester even when tester is turned off.
1.
Select cable type (UTP, FTP, or COAX).
2.
Select a cable category.
3.
Select a wire size
4.
Calibrate cable length.
5.
Enable or disable the Beeper for ON and OFF
Setup Procedure
1. Press SET key.
2. Press
enter key to set up through the selections.
3. Press ▼ ▲ keys to select the desired setup condition.
4. Press
enter key to move to the next setup selection, or press SET key to exit the setup mode.
5.3 Select a Cable Type
1. Press SET key to enter setup mode.
2. Press ▼▲key until the desired “cable” type is displayed, then press
enter key.
3.
Press ▼ ▲keys until the desired “category” is displayed, then press
enter key.
4.
Press ▼▲key until the desired “wire size” is displayed, then press
enter key.
5.
Press ▼▲key to choose the “CAL” function, then press
enter key.
