Elma 615A
side 23
Data Logger
Storing Data
Your thermometer is capable of storing up to 100 data locations.
Infrared
To store data from an infrared reading, pull the trigger. While holding the trigger, press the
MODE button until LOG appears in the lower left corner of the display; a log location
number will be shown. If no temperature has been recorded in the shown LOG location, 4
dashes will appear in the lower right corner. Aim the unit at the target area you want to
record, and press the laser/backlight button. The recorded temperature will appear in the
lower right corner. To select another log location, press the up and down keys.
Recalling Data
To recall stored data after the unit shuts off, press the MODE button until LOG appears in
the lower left corner. A LOG location number will be shown below LOG, and the stored
temperature for that location will be display. To move to another LOG location, press the
UP and Down keys.
Log Clear Function
The “Log clear” function allows you to quickly clear all logged data points. This function
can only be used when the unit is in LOG mode. It can be used when the user has any
number of LOG locations stored.
You should only use the LOG clear function if you want to clear all the Log location data
that is stored in unit’s memory. The “LOG clear” function works as follows:
(1) While in LOG mode, press the trigger, and then press the “down” arrow button until you
reach LOG location “0”.
Note: This can only be done when the trigger is pulled. LOG location “0”cannot be
accessed, by using the “up” arrow button.
(2) When LOG location “0” shows in the display, press the laser/backlight button. A tones
will sound, and the LOG location will automatically change to “1”, signifying that all data
locations have been cleared.
USB Function
This device affords transmitting the IR and Type K measurement data to the PC via USB.
Turn on or Shut off USB function:
Under MAX/MIN/DIF/AVG state, press LIGHT/LASER button until “USB” sign appears in
the right lower corner of the LCD. the USB function turn on.
Then, press the LIGHT/LASER button again until “USB” sign disappears. Thus, the USB
function shut off.
Please refer to the help file in software for details.
