page 7
7. Canopy Assembly.
8. Blade Assembly.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
antenna
canopy
hanging bracket
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with
slotted
holes in canopy, and then lower
canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in canopy with loosened
screws in hanging bracket. Twist canopy to lock.
Re-insert the other 2 screws and secure all
screws with Phillips screwdriver.
motor assembly
Time Saver
: Rubber washers for blade screws
can be set on each blade screw prior to
installing the blades.
Locate 10 blade attachment screws and rubber
washers in one of the hardware packs. Locate
the plate at the top of the motor assembly.
Please note the five "5's" that are stamped into
the plate-you will use the holes on either side
of the 5 to attach each blade. Align holes in
blade with motor holes in plate as previously
described. [
Be sure to note label on blade
indicating
THIS SIDE UP
.] Insert 2 blade screws
(along with rubber washers) with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat this procedure with
remaining blades.
Note
: Tighten blade screws twice a year.
blade
attachment
screws
and
washers
blade
plate
