CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the
transmitter.
Use the same number sequence
used when wiring the wall control in Section 6
(page 6).
Note
: The dimmer switch (labeled
D
and
X
) has
been pre-set to the "ON" position (
D
). If you do
not wish to have dimming capability, please
move the switch to the "OFF" position (
X
).
Install 9-volt battery (provided) in transmitter
and then replace the battery cover.
IMPORTANT
: Store the transmitter away from
excess heat or humidity. To prevent damage to
transmitter, remove the battery if not used for
long periods.
Restore electrical power and then set slider
switch on wall control to the ON position. Within
30 seconds of turning on the wall control, press
the "OFF" button, located on the front of the
transmitter, for 5 seconds or until lower light
blinks twice. Test the light and fan functions to
confirm the learning process is complete--see
Section 13.
page 9
11. Wall Control Operation.
10. Automated Learning Process./
Activating Code.
battery
cover
dimmer
switch
dip
switches
TRANSMITTER
(
back
)
TRANSMITTER
(
front
)
ON/OFF slider switch
- turns
wall control
ON or OFF
HI
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
FAN OFF
button - turns
fan
OFF
U/L
button - turns
upper light
ON/OFF when pressed
once; dims
upper light
when pressed and held down
D/L
button - turns
lower light
ON/OFF when pressed
once; dims
lower light
when pressed and held down
REV button
- used to REVERSE blade direction (fan
must be set on
low
before
reversing blade direction)
