page 7
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch.
Wire the WALL CONTROL
with wire
connectors provided
as shown in diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires
and taped wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended for
use.
Write down number sequence for use in Section
10.
Note
: Since this fan comes with a LED light kit, the
dimmer switch (labeled
D
and
X
) has been pre-set to
the "ON" position (
D
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
X
).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided with the wall
control.
Modifications not approved by the party responsible for compliance could void
the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
6. Wiring. (cont.)
green
green/
green/
bare
bare
ground
ground
green/
bare
ground
(wiring for wall control)
code
switches
wall
control
plate
outlet box
dimmer
switch
1
2
3
4
X
D
black (OUT to fan)
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
black (OUT to fan)
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed, and then
tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted
holes in canopy cover with screw heads in bottom
of canopy. Turn canopy cover to right (clockwise)
until it stops.
canopy
hanging bracket
screw
screw
canopy cover
