9/32
MP120
1.2.3 DK2000M INSERTER
The DK2000M is the inserter used for the DK20 programmable keys. The device
features 2 normally closed (N.C.) non-balancing alarm inputs, with reference to the
negative. Its front includes 4 signalling LEDs (one for the system status, three for the
area or sector status). The inserter address configuration takes place through jumpers.
By using special adapter frames, the DK2000M inserter may be included, as a core,
within the following civil networks: BTicino Living International, BTicino Light, BTicino
Living, Gewiss Playbus, Ave Habitat Sistema 45, Vimar Idea, Vimar 8000.
1.2.4 DK3000M PROXIMITY INSERTER
The DK3000M is the inserter used for the DK30 transponder keys. The device features 4
signalling LEDs (one for the system status, three for the area or sector status). The
inserter address configuration takes place through a rotary switch. The DK3000M
inserter does not control alarm inputs.
By using special adapter frames, the DK3000M inserter may be included, as a core,
within the following civil networks: BTicino Living International, BTicino Light, BTicino
Living, Gewiss Playbus, Ave Habitat Sistema 45, Vimar Idea, Vimar 8000.
1.2.5 DK20 PROGRAMMABLE KEY
The DK20 is a programmable key for full or partial system actuation and deactivation.
The code is generated at random by the control unit, with over 4 billion possible
combinations. Up to 16 keys can be programmed, and each key may be individually
enabled or disabled and assigned a descriptive name. To use the DK20 programmable
key, the DK2000m inserter shall be available in the system.
1.2.6 DK30 TRANSPONDER KEY
The DK30 is a transponder key for full or partial system actuation and deactivation. To
use the DK30 key, the DK3000M inserter shall be available in the system. Each key
features a univocal, factory-set code, with over 280,000 billion possible combinations.
1.2.7 EP100 EXPANSION
The EP100 is a parallel expansion module with 8 programmable alarm inputs (N.C.,
single balancing, or dual balancing), 1 auxiliary input, 1 balanced 24-h input, 1 tamper
input, and 4 freely programmable electric outputs. It allows detectors to be connected in
the traditional parallel fashion.
NOTE. The sensors connected to the expansion shall be powered by the control unit.
1.2.8 ES100 EXPANSION
The ES100 is a serial expansion module with 8 alarm inputs, 1 auxiliary input, 1
balanced 24-h input, 1 tamper input, and 4 freely programmable electric outputs. It
allows detectors to be connected in a serial fashion (they shall incorporate the UR1Z
interface module for connection to the secondary bus).
NOTE. The sensors connected to the expansion shall be powered by the control unit.
1.2.9 UR1Z MODULE
This is an interface module to be used with the ES100 expansion.
