2/20
ACCESSORIES INCLUDED
In addition to the Bell box itself, the following accessories are also included in the package:
a) 4 x large wall plugs
b) 4 x 4mm x 30mm Philips screws
c) 4 x 1.5V D alkaline cells
DIP SWITCH TABLE
Remove the cover by unscrewing the single screw located at the bottom. In the middle of the “L-shaped”
PCB board, you can see a dip switch set which consists of 7 dip switches. The function of each dip
switch is listed as table below.
The DIP Switch is either ON or OFF. Top position indicates ON and bottom position indicates OFF.
SW1
Siren Learning
OFF
Normal
operation
ON
Learn-in
mode
SW2
Strobe Activation
OFF
On for alarm period
ON
On until reset
SW3
SW4
Siren Duration
OFF OFF
3
min.
ON OFF
5
min.
OFF ON
10
min.
ON
ON
1 second (test)
SW5
OFF
Slave
ON
Stand-alone
SW6
Memory Reset
OFF
Normal
ON
Clear
Memory
SW7
Reserved
POWER SUPPLY
Bell box is powered by 4 D-cell alkaline batteries with a life expectancy of over 3 years.
The Bell box can detect if the battery is low. Low battery detection operates where the Bell box has
enough power to typically operate for 1 month before complete exhaustion. The siren low battery signal
will be enunciated by five beeps when arming / disarming.
BELL BOX FUNCTION OVERVIEW
•
Siren Memory Clear
The siren resets and clears all memory contents by removal of batteries. Wait for 1 minute and
slide dip switch 6 to ON position before re-inserting the batteries. The siren will produce a short
confirmation tone. If dip switch 6 is turned OFF, then siren ID code learned will reset every time
when the siren has a power-up sequence.
ON
OFF
