1000003419 (Rev. A - 03/16)
Page 13
How to Provide Electricity
Plug the cord into a properly grounded wall outlet. At this moment, the pump will begin to move water from the tap to the hot and cold tanks. It will take up
to 35 minutes to fill the tanks for the first time. During this period the pump will run continuously. This is normal.
Notice:
1.
This unit will not dispense hot or cold water until the switches are activated.
2.
The water cooler shall plug into a ground fault interrupter receptacle.
To activate, push the top side of the power switches in to start the heating and cooling water.
• If you do not want to heat water, push the bottom side of red switch in.
• If you do not want to cool water, push the bottom side of green switch in.
How to Dispense Water
This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors can accumulate in the tank and lines. It is important
to flush the water dispenser with the filters installed for a minimum of three minutes prior to first use and after the filters have been replaced.
Dispensing Cold Water (≤50°F)
After setup, it will take up to 1 hour to get water to a maximum cold temperature. During this time the compressor could run continuously. This is normal.
1.
Position bottle, glass, pitcher or cooking pot below water spout.
2.
Press the cold water control downward to start the flow of cold water.
3.
Release the control once the desired fill level is achieved.
Dispensing Hot Water (≥180°F)
Caution:
This unit dispenses water at a temperature that can cause severe burns. Avoid direct contact with hot water. Keep children and pets away from
the unit while dispensing. Never allow children to dispense hot water without proper and direct supervision. Unplug the unit to prevent unsupervised
use by children.
After setup, hot water will be available in 15-20 minutes. (Indicator light will turn off when heating is complete.)
1.
Position bottle, glass, pitcher or cooking pot below spout.
2.
Slide red button away from you and depress the hot water control downward to start the flow of hot water.
3.
Release the control once the desired fill level is achieved.
