Page 7
1000002684 (Rev. A - 07/18)
EZS8WS_2G, LZS8WS_2G, LZSDWS_2G
Service: Inspection/Replacement
• Inspect Bottle Filler and Cooler twice each year for proper operation and performance.
• Inspection of the unit will require disconnecting electrical supply, removal of panels, etc. and reassembly and return to service practices.
1. Lower Front Panel and Upper Shroud: To access the refrigeration system and plumbing connections, remove four (4) screws from bottom of
cooler to remove the lower front shroud. To remove the upper shroud for access to the pushbars, regulator, solenoid valve or other
components located in the top of the unit, remove lower shroud, disconnect drain, remove four screws from tabs along lower edge of upper
shroud, unplug two wires and water tube.
2. Bubbler
: To remove the bubbler, first disconnect the electrical supply. The underside of the bubbler
can be reached through the access panel on the underside of the upper shroud. Remove the
access panel by removing the retaining screw. To remove the bubbler, loosen locknut from the
underside of the bubbler and remove the tubing from the quick connect fitting (see above). When
installing replacement bubbler and pedestal, tighten locknut only to hold parts snug in position.
Do
Not Overtighten.
After servicing, replace the lower front panel and four (4) screws.
3. Switches Behind the Push Bar: The regulator in an EZ cooler is always held fully open by the use
of a single regulator nut. Water is not dispensed until the pushbar is depressed to
activate a switch which then opens a solenoid valve. When installing the regulator nut, the
regulator spring must be depressed while turning the nut.
To remove sidebars, from the inside compress the flared tabs and pull out careful. To reinstall side
pushbars, the front of the pushbar is inserted first. While keeping the switch depressed, snap the
rear of the pushbar into position.
4. Cleaning In-Line Strainer: Unscrew the cap of the In-Line Strainer. Remove screen and rinse
thoroughly with water. Insert screen back into solenoid valve and screw cap on. Make sure the
o-ring is placed properly.
Replacement Parts: WaterSentry Filter Parts List
Item
No.
1
2
3
Part No.
51300C
98926C
0000000746
Description
Filter Assy-3000 Gal.
Kit-Filter Head Fitting Includes
John Guest Fittings
Assy-Filter & Bracket includes Filter
Head/Mounting Bracket/John Guest
Fittings/Screws
1
2
3
2
WATER FILTER EXPLODED VIEW
