97414C (Rev. K - 8/03)
ESRC8*1F, 2FJO, 3FJO ESRC13*1F, 2FJO, 3FJO
PAGE 3
FIG. 3
Stream height is factory set at 35 PSI. If supply pressure varies greatly
from this, remove items 31 and 32 and adjust screw on item 34. Clockwise
adjustment will raise stream and counter-clockwise adjustment will lower
stream. For best adjustment, stream should hit basin approximately 6-1/2"
(165mm) from bubbler.
NOTE:
WHEN INSTALLING REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN NUT (ITEM 12) ONLY
TO HOLD PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
BASIN
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
START UP
Also See General Instructions
8) Replace the front panel and secure by retightening all screws.
FIG. 4
10
11
12
8
9
WRAPPER
34
32
33
31
35
36
INSTALLATION OF COOLER AND TRAP
1) Hang the unit from the mounting box by placing tabs from the upper backside of the basin over top of the
upper flange on the mounting box, and mount trap, as shown in Figure 2.
NOTE:
Mounting box and trap MUST be supported securely. Add fixture support carrier if wall will not provide adequate support.
IMPORTANT:
2) Secure cooler in place by positioning fastening clips as shown in Figure 2 - Detail B.
3) Install straight valve for 3/8 in. O.D. unplated copper tube.
4) Remove the access panel on the underside of the cooler and set it aside.
5) Connect water inlet line--See Note 4 of General Instructions.
6) Remove the slip nut and gasket from the trap and install them on the cooler waste line making sure that the end of the waste
line fits into the trap. Assemble the slip nut and gasket to the trap and tighten securely.
