4. Connect the power supply and plug it into the wall socket.
Note:
After the power is on, the following interface will show for 3s. Then enter user usage state.
Note:
Do not use a wall socket controlled by a switch.
Initial Setup
To be performed after “Installation”
1. For the fi rst use after installation, you should add salt to the salt tank and seven liters of water. This will create a saturated
brine(26% NaCL), to facilitate startup and operation.
2. Switch on power. Press the “Return” button and go in the Backwash position. Slowly open the water supply valve to ~25% fl ow
and water will fl ow into the resin tank. You will be able to hear the sound of air coming out from the drain pipeline. Flush the
resin tank until the outlet water is clean. It will take 8 minutes to fi nish the whole process.
Note:
If water fl ow is too fast, the media in the tank can be damaged.
3. Press RETURN to go to Brine & Slow Rinse and start the cycle. The air check valve will close when the control valve
has fi nished sucking brine and then slow rinse will start. The process will take 50-60 minutes.
4. Press RETURN to go to Fast Rinse and start the cycle. The process is about 4 minutes.
5. Press RETURN and the control valve will return to the Service Status and start to run.
6. Press RETURN to go to Brine Refi ll position, record the time and adjust it as required.
7. Press RETURN got to the Service Status. It will take 240 minutes for the salt to make a saturated brine.
Note:
When the control valve enters into the regeneration status, the program will be fi nished automatically according to the
setting time; if you want one of steps terminated early, you can press RETURN.
Note:
During the setup process, check the system and all connections for leak. Turn of the water at the inlet valve before
attempting to repair any leaks.
Display Operation
Down
Up
Display Area
Menu/Confi rmation
Manual/Return
Water System
In-Service
Remaining: 1.5m³
Cur. F. R.:3.2m³/h
1000003996 (Rev A - 05/2017)
Page 5
