Please detach these instructions and give to day to day end user of the system.
UK Head Office, Station Road, Coleshill, Birmingham B46 1HT
Tel: +44 (0) 1675 468 222 Fax: +44 (0) 1675 464 930
www.elkay.co.uk
All wiring should be carried out by a competent person or a qualified electrician and
should be fitted to IEE Wiring regulations BS7671.
The circuit should be isolated before carrying out any work. Failure to adhere to the
instructions will invalidate the warranty.
The Company‘s policy is one of continuous improvement and reserves the right to
change specifications at any time without prior notice.
RPM-489 SUPPLEMENT
1. Feedback LED -
GREEN
(when pressed)
9. ON/OFF Button
2. SET Button
(To SAVE changes)
8. LUX Level Control
(Harvesting Level)
7. Reset to Automatic
Daylight Harvesting
6. 25% Instant Brightness
3. DALI Scene Control
Selects scenes 1-16 in pre-set
levels of brightness stored in the
DALI luminaires ballasts
4. 100% Instant Brightness
5. 50% Instant Brightness
Elkay easyDALi Remote Control
End User Handset Instructions
Instruction Data | 374-DREM
Fitting and operation instructions
1. Feedback LED
- Green when button is pushed to indicate
easyDALi remote buttons have been pushed.
2. Set Button
- Saves changes made.
a.
The set button is used to store the harvesting
illumination level when in room option. If the illumination
has been changed temporarily for some reason the preset
level will be restored the next time the luminaires
are turned on or the harvester state is reset. Pressing
the set button sets the current illumination level as
the preset for the harvester.
3. DALI scene control
- 16 levels of pre-set brightness to
enable you to select precise level of required
brightness from luminaire. The scene up and down
buttons step through the stored scene information
of the ballasts within the luminaires. If the luminaires have
no scene information these buttons have no function
but will halt the harvester. To return to harvesting press the
‘Reset to Automatic Daylight Harvesting’ button.
4. 100% Instant Brightness
5. 50% Instant Brightness
6. 25% Instant Brightness
7. Reset to Automatic Daylight Harvesting
8. Lux Level Control
– This enables you to set the
required lux level in the room. The amount of internal
light combined with external daylight is measured
by the easyDALi PIR to produce the required output of
brightness at the luminaire in the room. The lux button on
the Remote Control can be used to set the exact lux level
that lights will operate at and set the daylight harvesting
level. To avoid inconvenient flashing in this mode, there is
a time delay around the light level set to avoid lights
coming on and off when the light level is close to or equal
to the lux level set.
9. ON/OFF Button
- ON and OFF button and override off.
The luminaires will be turned off for a pre-set period then
harvesting mode will be restored. If presence is detected
the luminaires will be turned on but otherwise stay off.
While in override off the signal LED on the Elkay DALI PIR
will flash white. Pressing override off again will restore the
Elkay DALI PIR to harvesting.
What is Daylight
Harvesting?
Daylight harvesting simply
means that the easyDALi
PIR sensor takes account
of how much natural light is
available and increases or
decreases the brightness of
the lighting that you require
in your room or zone. As a
result, you use less power,
save energy and reduce
your lighting costs.
