Installation
In
s
ta
ll
a
ti
o
n
Attention
Prior to installation, make sure to check for the following parts and fittings.
Installation Procedure
Installation Procedure
19
In
s
ta
ll
a
ti
o
n
20
In the event of a power failure
▶
In the case of a power failure during the use, the product will stop functioning.
▶
Unplug the power cord from the wall outlet and shut off the water supply.
In the event of suspension of water supply
▶
The product can not be used.
▶
Check to make sure your water supply is turned on.
▶
If problem persist call for support.
(If air or foreign matter gets into the main unit, filter life may be shortened)
1
Place the unit on the planned installation location
and screw the flexible tube clockwise tightly to the
water outlet hole positioned on the top of the unit.
Do not over tighten.
2
Press the stem elbow into the water in_flow/out_flow
hole located on the bottom of the unit until you
hear a click
5
Plug in the device.
(If power is applied, the melody "ding dong dang" comes in.)
3
Measure the length between the location where the
device will be located (on counter) and the water
faucet where the diverter (adapter) will be installed.
Cut a sufficient length of hose to allow it to be
connected to the water supply inlet on the rear of
the unit (from faucet to the unit).
※Make sure that you k
eep the length under 5 meter
between the unit and the water faucet. You may have
to use the pressure pump or larger hose size to
connect water line if water pressure is too low. It is a
good idea to leave a few extra inches of length so
faucet can still be rotated.
4
Cut a 50-to-70cm length of drain hose and
connect it to the drain on the rear of the product. Make
sure the drain hose is positioned lower than the
product.
5
“ON”
4
1
2
3
4
