Rev.060116-D
4
6. Wireless 5-12 volt trigger (Item F, Fig 5)
: The RF
remote control serves as a dual purpose, independently as a
handheld remote control, or in conjunction with the
Wireless 5-12 volt trigger cable. The radio frequency
technology can be programmed to send a wireless signal to
synchronize its drop/rise with the projector’s power cycle.
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1
: Connect one end of the 3.5 mm wireless 5-12 volt trigger cable to the RF remote.
Step 2
: Connect the other 3.5 mm end of the wireless 5-12 volt trigger cable to your projector
Step 3
: Make sure to unplug your screen from the power outlet
Step 4
: Hold the
UP
button on your RF remote
Step 5
: While holding the
UP
button, plug the screen back to the power outlet
Step 6
: Wait 5 seconds and then release the
UP
button
Step 7
: Your 5-12V wireless trigger should now be activated with your screen and ready to be used and
able to control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20-
30seconds for full off and on cycle each time)
Hardware Parts List for Evanesce B Series
Please make sure all parts listed below are included before proceeding with the installation.
Hardware Parts List for above ceiling installation
A. Suspension Bracket x 2
B. Suspension Bar x 4
C. End Flange x 2
C. M8x16mmx1.5mm washer x 8
D. M6x13mmx2mm washer x 8
E. M8 nut x 4
F. M6 nut x 4
G. M8x40mm hex screw x 4
H.M6x20mm screw x 4
DC
5-12V
out
The back ofthe
projector
Wireless 5-12V trigger cable
UP
Stop
Down
Fig 5
5. 5-12 volt trigger (Item D, Fig 4):
The built-in 5-12V
trigger input allows your screen to synchronize its drop &
rise with the projector’s power cycle. The screen deploys
when the projector powers up and will retract when the
projector powers down. The 5-12 volt RJ45 cable connects
to your projector’s trigger output via a separate cable that
may or may not be provided by the manufacturer of the
projector. The trigger feature will not work without an
output cable from the projector, but it can be tested by
connecting the Red (+) and Green (-) cable to a 9-volt
battery.
RJ45 Input
5-12 volt trigger cable
Fig.4
