042717DR
8
Edge trim Installation
Included is a black edge trim that provides an elegant ultra-thin bezel finish
1.
Place the assembled frame on a flat and clean surface. The projection screen surface should be facing up.
a.
As an option, Black Tape is supplied to cover any possible gaps between the pieces of the bezel trim. Align
the tape with the edge of the screen, as shown in Figure 1. Once properly aligned, apply the black tape to
the center of the top and bottom of the screen material.
Figure 1
2.
Without removing the adhesive tape, place all the trim pieces along the edge of screen material. Adjust the trim so
that the top and bottom trim pieces are touching and show no gaps in the center. (Note: The Elite logo should be
positioned on the bottom right). Refer to Figure 2 below for a visual reference.
NOTE: Make sure the bottom edge trim with the Elite Screens logo is installed on the correct side. The back of the
material should be labeled with a DOWN sticker to indicate the material is facing in the down position. The Elite
Screens logo should be installed on the DOWN side
3.
After properly aligning all trim pieces, carefully remove trim piece
A
(see Figure 3 below). Remove the inside
backing of the tape and place the trim piece in its original position on the frame. Repeat this step for the remaining
trim pieces in the following order: B-C-D-E-F.
Plastic corner sleeve x4pcs
Edge trim x 6 PCS
Black tape x1pcs
Screen Material
The black tape
The black tape
Trim
strip
Front Side
Back Side
TIP:
Align the trim starting
from the center to reduce
gapping. Any gaps left at
the corners will be
covered by the corner
sleeves.
Figure 2
White area
signifies
corner gap.
