Rev.042417 DR
6
www.eliteproav.com
Deprogram one remote
1.
Enter the coding state.
a.
With the programmed remote,
press and hold
the
STOP
button.
b.
You should hear the continuous short beeps. (You are in the coding state.)
2.
Deprogram one remote.
a.
Press
the
DOWN
button.
b.
You should hear 3 short beeps.
c.
Your remote has now been erased from the screen's memory.
Deprogram ALL remotes
1.
Preparation.
a.
Have a thin, sharp object ready.
b.
Remove the cover on the back of the remote.
c.
Locate the reset button for next steps.
2.
Enter the coding state.
a.
With the programmed remote,
press and hold
the
STOP
button.
b.
You should hear the continuous short beeps. (You are in the coding state.)
3.
Deprogram ALL remotes.
a.
Press the reset button on back of remote with a thin, sharp object.
b.
You should hear 3 short beeps.
c.
All remotes have now been erased from the screen's memory.
4. 5-12 volt trigger (Item D):
The built-in 5-12V trigger input allows your screen to synchronize its drop &
rise with the projector’s power cycle. The screen deploys when the projector powers on and will retract when
the projector powers off. Plug the 3.5mm end to the projector’s output port and the 2.5mm end to the trigger
port on the screen’s case (see example images for port location).
Note: You may need to enable this feature in your projector settings.
3. IR “Eye” Receiver
(
Item C)
: The Infrared functions by direct line of sight contact with a beam range of 25
feet. The IR “Eye” receiver plugs directly into the IR port located on the left side end of the screen (see example
images for port location). Once connected, simply aim the IR remote at the IR “Eye” receiver to control the
screen.
1. RS485-B
2. RS485-A
3. Manual control switch (UP)
4. Manual control switch (STOP)
5. Manual control switch (DOWN)
6. Manual control switch public line
5. RS485
A. RS485 Port Setting
1. Baud Rate: 2400
2.Data Length: 8
3. Parity: N
4. Start Position: 1
5. Stop Position: 1
B. Control Codes
1. UP code:
0xFF 0xAA 0xEE 0xEE 0xDD
2. STOP code: 0xFF 0xAA 0xEE 0xEE 0xCC
3. DOWN code: 0xFF 0xAA 0xEE 0xEE0xEE
Reset
Button