Rev.042417 DR
3
www.eliteproav.com
Installation Instructions
Wall Installation (200”/235”/250” diagonal models)
The installer must ensure that the fasteners used are of adequate strength and suitable for the installation
location. Be sure to use hardware that is rated for the screen’s weight. The steps below are a general method
of wall installation. The parts listed below are
not included.
1. Measure and mark the (L) distance between the two holes on the back of each bracket.
2. Drill a pilot hole for each screw/bolt on the marked areas.
3. Install the screw/bolt in the marked areas, leaving about 1/8” of an inch as shown in Fig. 1
4. Hang the screen by aligning the end cap holes to the screws, shown in Fig 2.
Suspended Installation (200”/235”/250” diagonal models)
The installer must ensure that the fasteners used are of adequate strength and suitable for the installation
location. Be sure to use hardware that is rated for the screen’s weight. The steps below are a general method
of suspended ceiling installation. The parts listed below are
not included
, except for the
snap link hook.
1.
Measure and mark the (L) distance between the two holes on each side bracket.
2.
Drill a pilot hole in the ceiling for each suspension eyebolt.
3.
Screw an eyebolt into the ceiling at the marked areas according to the (L) measurement.
4.
Attach the snap link through the end cap bracket and connect it to a chain of the preferred length.
5.
Connect the chain to the eyebolt in the ceiling.
（
Fig.1
）
（
Fig.2
）
L
L
Wall