03282019JA
6
U
-00140
UP
Stop
Down
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1:
Connect one end of the 3.5 mm wireless 5-12 volt trigger cable to the RF remote.
Step 2:
Connect the other 3.5 mm end of the wireless 5-12 volt trigger cable to your projector
Step 3:
Make sure to unplug your screen from the power outlet
Step 4:
Hold the UP button on your RF remote
Step 5:
While holding the UP button, plug the screen back to the power outlet
Step 6:
Wait 5 seconds and then release the UP button
Step 7:
Your 5-12V wireless trigger should now be activated with your screen and ready to be used and able to
control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20- 30seconds
for full off and on cycle each time)
5. 5-12 volt trigger (Item D, Fig 4):
The built-in 5-12V trigger
input allows your screen to synchronize its drop & rise with the
projector’s power cycle. The screen deploys when the projector
powers up and will retract when the projector powers down. The
5-12 volt RJ45 cable connects to your projector’s trigger output
via a separate cable that may or may not be provided by the
manufacturer of the projector. The trigger feature will not work
without an output cable from the projector, but it can be tested by
connecting the Red (+) and Green (-) cable to a 9-volt battery.
Fig.3
Fig.2
IR “eye” receiver
3 Way Wall Switch
(does not have IR sensor)
4. 3-Way Wall Switch
(
Item C, Fig 3
): The 3-way wall switch is a wall mount control box with an
up/stop/down button and plugs directly into the screen’s RJ-45 input.
For more information, technical
support or your local Elite
ProAV® contact, please visit
DC 5-12V out
Wireless 5-12V
trigger cable
The back of the
projector
Fig 5
6. Wireless 5-12 volt trigger (Item F, Fig 5)
: The RF remote
control serves as a dual purpose, independently as a handheld
remote control, or in conjunction with the Wireless 5-12 volt
trigger cable. The radio frequency technology can be
programmed to send a wireless signal to synchronize its drop &
rise with the projector’s power cycle.