Elite ProAV Saker Tab-Tension CineGrey 5D Series, User Manual, Page: 4 / 6

03282019JA 4 U -00140 www.eliteproav.com
Hardware Parts List
Please make sure all parts listed below are included before proceeding with the installation.
A. Wall/Ceiling
mount bracket
x2
B.
M5x60
Screw x6
C. M12
Dry-wall
anchor x6
D. Bracket
connector x2
(installed on
housing)
E. M5x11
Bolt
Screw x4
F. M5x25mm
round head
cross screws x2
G. M5x30mm
eyebolt screw
& M5 nut x2 H.
Snap
link x2
Installation Instructions
For installation assistance, please consult a professional Installer. Elite ProAV is not liable for faulty
installations. Two or more people are required while one holds the screen in place.
A. Wall Mount
Flush mount (movable position)
This mount method allows the screen to slide horizontally.
1. Determine where the screen will be installed. Then, measure and mark the distance between the top and bottom
screw holes from each
Wall/Ceiling mount bracket
(A).
2. Drill a hole on all marked areas and install the brackets with the dry-wall anchor (C), M5x60 screw (B), Make sure
both brackets are properly leveled.
3. Hang the screen by placing the
downward “catch” located on the back over the brackets upper “catch”.
4. After making sure the screen is secured, you can slide it left / right to properly center it in position.
5. Lastly, screw the
M5 screw (F) into the upper hole of the bracket to add additional support for the screen.
B. Ceiling Mount
Ceiling Mount (movable position)
This mount method allows the screen to slide horizontally.
1. Determine where the screen will be installed. Then, measure and mark the distance between the top and bottom
screw holes from each
Wall/Ceiling mount bracket
(A).
2. Drill a hole on all marked areas and install the brackets with the dry-wall anchor (C), M5x60 screw (B), Make sure
both brackets are properly leveled.
3. Hang the screen by placing the
downward “catch” located on the back over the brackets upper “catch”.
4. After making sure the screen is secured, you can slide it left / right to properly center it in position.
5. Lastly, screw the
M5 screw (F) into the upper hole of the bracket to add additional support for the screen.
Front view of bracket
(A)
Side view of bracket (A)
Wall
M5x25MM round
head cross screws
(F)
Front view of
bracket (A)
M5x25MM
round head
cross screws (F)
Ceiling