6.
Fix each door wheel into position by pushing the bolt provided through the centre of the
wheel and then through the hole in the top door panel from underneath (i.e. from the inside of the
door). Put the washer over the bolt and secure with the nut provided, tightening until there is no
movement on the bolt. The nuts are lock-nuts and are harder to put on than the normal nuts in gen-
eral assembly. The wheel will revolve freely because it has ball bearings in it.
7.
Slip the nylon door skids on each end of the bottom panel.
8.
Turn the door over and insert the black rubber draught excluders in the groove (bolt slot) in
each side piece of the door. Push up to the top of the door and trim off the surplus at the bottom.
With a pair of pliers squeeze the groove together at the bottom so that the rubber will not slip
down when the door is in its upright position.
9.
Do not fit the door at this stage, see later in the plan for this detail.
Summary of Contents for iGrow
