Elite Greenhouses 2'3'' Wide Easy Grow, Instructions & Illustrations

Page: 15 / 32

PROCEDURE
1. Lay out the component parts on a flat surface, with the inside of the bars uppermost, the
gutter and cill are facing the ground. (Key point).
2.
Thread the glazing beading into the glazing bars and the gutter. It is not required on the inside
groove where a door will be situated.
3.
Insert 3 bolts into each glazing bar and attach the gutter/eave to the glazing bar as illustrated
below.
4.
The cill will bolt to the bottom of the glazing bar in a similar manner. Before securing the nut
onto the bottom bolt, place the diagonal braces over the bolt. This bracing angle bar must be
arranged so that the inside of the angles are facing inwards.
(Key point) .
5.
Attach the short flat bar pieces (utilising the bolts that were inserted and located in the middle
– see No.3 above) to the middle of glazing bars, ensuring that they are parallel to the eave/
gutter and cill. With the 4’ x 2’ model, you must decide if the door is going in the left or right
hand bay. The flat bar and angle will go in to the opposite bay.
6.
Ensure that all joints are tight and the frame is square before tightening the nuts.
The front frame is now complete,