Eliet Superprof 2000, Manual

Page: 69 / 76

E nglish 13.2Belt conveyor
The belt conveyor is installed at the rear of the machine and transports the shredded material
upwards. The length of the belt conveyor is 2.5m. The height of the belt conveyor can be adjusted from
1.65m to 1.90m. It is driven by a hydraulic m otor that is independently acti vated. Care must be taken
to ensure that the belt conveyor is switched on when you start feeding material.
Attaching the belt conveyor
Cauti
on :
Prior to fitting the belt conveyor to the machine, always be sure to switch off
the engine.
• Remove the safety guard cover (M8, SW13)
Warn
ing :
The cover is part of the safety guard and prevents you from coming into contact
with the blades. Removing this cover results in an inferior degree of protection. Be
extremely careful and never insert your hands underneath the safety guard.
• Refit the spring, flat washer and bolt into their locations place, so as not to loose them.
• Using 2 persons, hold the belt conveyor at both sides.
Cauti
on :
The belt conveyor weighs approximately 45 kg; do not underestimate this
weight.
Prevent back injuri es by bending your knees when lifting the weight.