Eliet Superprof 2000, Manual

Page: 60 / 76

E
n
g
li
sh
• Carefully remove any joi nting compound residues so that no residues enter the oil tank.
• Replace the fil ter.
• Be over generous in the appli cation of new joi nting compound for a good seal.
• Refit the fil ter and the drain plug.
• Fill the oil tank with fresh oil (see Appendix A for recommended oil).
• Clean off any spilled oil and inspect for signs of leakage.
Caution :
Do not all ow the suction hose, oil plug and filler cap to become dirty.
This minimises the chance of a hydraulic defect and premature wear.
11.4.8 General lubrication
In view of the fact that the shredders often operate in extreme conditions, ELIET considers it im-
portant to use high-quali ty material s. ELIET therefore recommends the use of special lubri cants
(from the assembly stage onwards).
The foll owing parts require regular lubri cation:
• Pivot points and friction surfaces (see A on page 42).
• Grease zerks (see B on page 42).
• Bearing (see B on page 43).
• Chains and gears (see D on page 43).
Caution :
Before performing lubri cation, make sure to switch off the engine and to remove
the key from the ignition switch. Gloves must also be worn during this
maintenance.