Eliet Minor 4S, Manual, Page: 21 / 58

English
21
9. Operating instructions
9.1 Preliminary checks
Caution:
Try making a habit of checking the following points before getting to work with
the machine:
Checklist
1. Check that the chipping blades are firmly in place and in good condition. For safety's sake,
tighten the blade bolts. If the blades need sharpening, this should be done first. Check the
blades and the blade holder for cracks and nicks and replace immediately as needed (see §
11.5.6, Reversing and replacing the shredder blades).
2. Check the oil level. Pull out the dipstick and check that the oil level is not below the minimum
mark (if necessary, read § 11.4.2 Checking the oil level of the engine).
3. Check that the fuel tank is full. If it is not, add fuel (see § 9.2 Refuelling).
4. Check that the air filter is not heavily soiled (if necessary, read § 11.4.3 Cleaning the air filter).
5. Check that the cover plate at the back of the machine is attached correctly.
6. Check that the belt tension is correct (if necessary, read §11.4.5 Checking belt tension). If it is
not, it must be adjusted (if necessary, read §11.5.5. Belt tension adjustment).
7. Prior to starting to work, the operator must check that all the protective covers are in place
and correctly fixed.
8. Prior to starting to work, the operator shall verify that the shredding chamber and the turbine
are free of any chips.
9. Check that all safety provisions on the machine still function (see § 7.2 Safety features).
Once these items have been checked and approved, you can prepare the area of operation (see
§ 9.3 Preparing the work site) and move the machine to the work site.
9.2 Refuelling
When petrol in the machine is running low, fuel must be added. The use of fresh petrol is
recommended at all times. Use unleaded petrol, preferably with an octane index of 98 or 99.