ELICA SPOT PLUS ISLAND IX/A/90, Instruction On Mounting And Use Manual, Page: 19 / 168

18
Electrical connection
The mains power supply must correspond to the rating
indicated on the plate situated inside the hood. If provided with
a plug connect the hood to a socket in compliance with current
regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area, after
installation, apply a double pole switch in accordance with
standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in
accordance with installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
This type of cooker hood must be fixed to the ceiling.
Very heavy product; hood handling and installation must
be carried out by at least two persons.
Before beginning installation:
• Check that the product purchased is of a suitable size for
the chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also
relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other
supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
Operation
1 = ON/OFF – Speed increase
2 = Lights ON/OFF
3 = Selection of the desired function
4 = Setting the function in use
5 = The display shows:
a –
list of available functions
b – indicator of the function currently in use
c – indicator of the speed in use
d – clock / data related to the function in use
e – saturation of the anti-grease filter
f – saturation of the carbon anti-odour filter
Available functions
SPEED
Switch on/Speed increase:
- press button 1 to switch on the hood
- press button 1 to go to the next speeds, until the hood is
switched off
The extraction speed is shown on the display (c), in the
following manner:
1st
speed performance
40% ***
2nd
speed performance
60% ***
3rd
speed performance
80% ***
high
speed performance
100% ***
OFF
*** the percentage displayed refers to the indicative value of
the performance
The high speed is timed for 10 minutes; to interrupt the timing
and switch off the hood press button 1 .
NB= the speed might increase automatically during use, this
is because the control is fitted with a system that protects the
display in case of overtemperatures.