ELICA PRF0098375, Instruction On Mounting And Use Manual

Page: 27 / 148

27
or if the plug is not located in an accessible area, after
installation, apply a double pole switch in accordance with
standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in
accordance with installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
The accessories for ceiling mounting are not provided as
ceilings of different materials require different types of fixing
accessories.
Use mounting systems suitable for the ceilings of the
premises and the weight of the equipment.
For more details and in case of doubt, in order to ensure
proper installation of the product, we recommend that you
contact a dealer and a specialized technician.
The chimney is a CRISTALPLANT ® product, it should be cut
to size (see also illustrative drawings).
The installation of the hood and the cut of the chimney must
be performed by a qualified technician using suitable cutting
systems.
For cutting, we recommend the use of the Widia tools, and
equipment (e.g., band saw or similar) capable of cutting
marble, wood and mineral materials.
If possible, we recommend that you perform a cut in the
excess part of the chimney to check the suitability of the tool.
Visit www.cristalplant.it for more details on the material and
manufacturer.
The warranty will not be effective in the case of cosmetic
defects or damages caused and/or arising from failure to
comply with the above provisions, as the assembly and the
cutting of the chimney are activities pertaining to and under
the full responsibility of a third party other than the
Manufacturer.
Operation
This product is designed to work with an Elica remote control,
either supplied with the product or purchased separately as an
optional.
To control the hood via remote control, the affiliation
procedure must be carried out.
CAUTION!
To begin, the hood must be disconnected and then
reconnected to the power supply and the affiliation procedure
must be carried out within the first minute of connection to the
power.
Read the instructions supplied with the remote control, which
provide detailed instructions on affiliation and correct use.
Note: if the hood does not work, make sure that it is ON by
using the ON/OFF button.
The button is inside the hood and can be reached by
removing the grease filter.
Fig. 19
Maintenance
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS . Do not use abrasive products. DO NOT USE
ALCOHOL!
The hood should be cleaned regularly (at least with the same
frequency with which you perform the maintenance of the
grease filters) internally and externally.
The chimney and the body of the hood are produced in
CRISTALPLANT
®
.
Note: For more details on the material CRISTALPLANT
®
and
the Manufacturer, visit www.cristalplant.it
Maintenance of CRISTALPLANT
®
DAILY CARE
CRISTALPLANT
®
requires an easy and quick daily care.
It is enough to clea CRISTALPLANT
®
using soap and
water or common detergents to remove most of the dirt
and stains that may be deposited on the surface. It is
particularly recommended to rinse the surface well and to