15
PERFORATION FOUND ON THE SIDE OF THE
CONNECTOR LOCATED ON THE BACK OF THE
CONTROL PANEL.
18.
The double sided adhesive tape supplied should be cut
into 8 segments, then remove the protection covering
from both sides and apply the segments close to the
screws that fix the chimney flues to the structure (see
illustration for correct positioning).
19.
Apply the 4 masks (supplied) to cover the fixing points of
the lower sections of the chimney flue (ATTENTION THE
MASKS FOR THE LOWER CHIMNEY FLUE ARE
RECOGNIZABLE BY THEIR NARROWER WIDTH).
The wider masks are to be used for the upper chimney
flue, and should be cut to size.
20.
Hook the control panel to the opening slit so that the
ON/OFF light switch
is facing downwards.
Remount the carbon filter frame and the fat/s filter/s and check
the perfect functioning of the hood.
Only for products supplied in stainless steel and
aluminum:
Remove the protective covering taking care not to damage the
metal and finish (glazing).
Description of the hood
Fig. 1
1.
Control panel
2.
Grease filter
3.
Grease filter release handle
4.
Halogen lamp
5.
Vapour catcher
6.
Telescopic chimney
7.
Air outlet (used for filter version only)
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
A.
on/off light switch
B.
on/off aspiration switch and minimum
power selection
B+C.
medium power selection aspiration
switch
B+D.
maximum power selection aspiration
switch
