11
Complete Installation
Description of the Hood
1
Replace grease filters. See the “Maintenance” section.
I
WARNING
ELECTRICAL SHOCK HAZARD
I
WARNING
PLUG INTO A GROUNDED 3 PRONG OUTLET.
DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTER.
DO NOT USE AN EXTENSION CORD.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT
IN DEATH, FIRE, OR ELECTRICAL SHOCK.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center of the front of
the range hood liner.
A. Blower and light controls
B. Face plate
C. LED lamps
Controls
1
On/Off light button
2
Blower off and speed minimum button
3
Blower speed medium button
4
Blower speed maximum button
Operating the Light
The On/Off light button controls all lights. Press once for On
and again for Off.
Operating the Blower
The BLOWER SPEED buttons turn the blower on and control
the blower speed and sound level for quiet operation.
The speed can be changed anytime during fan operation by
pressing the desired blower speed button.
Press the BLOWER OFF button a second time to turn off the
blower.
Connect the Vent System
Vented Installations
1
Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
Non-Vented (recirculating) Installations
1
Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
2
Install charcoal filters.
See the “Available accesories” section.
2
Plug 3-prong power cord into a grounded 3-prong outlet
located inside the cabinet above the range hood.
3
Check the operation of the range hood fan and light.
See “Description of the hood” section. If range hood does
not operate, check to see whether a circuit breaker has
tripped or a household fuse has blown. Disconnect power
and check wiring connections.
NOTE
: To get the most efficient use from your new range
hood, read the “Description of the hood” section.
A. Screws - 4.2 x 15 mm (2)
8
Connect the lamps connector to the connector present
inside the hood as shown in drawing.
A
B
A. Lamp connector
B. Hood connector
9
Put the filters back in place and return the plate to its
original position
Summary of Contents for EUM628SS
Page 40: ......
