10
B
A
A. Mounting brackets (2)
B. Screws - 3.5 x 6.5 mm (4)
6
Attach the lower panel to the hood insert, with the
plate open, place four screws 3.5 x 6.5 mm securing the
panel to the previously placed brackets as shown in the
diagram.
NOTE
: If cabinet depth is greater than 12”, it is
recommended that the two
1
⁄
2
” metal spacers are
installed. Install to front and rear sides of the face plate with
round head 3.5 x 9.5 mm screws as shown in drawing.
A. Face plate
B. Screws - 3.5 x 6.5 mm (4)
A. Front and rear
spacer
B. Screws - 3.5 x 9.5
mm (4)
7
Install the two 4.2x15 mm screws located on the sides of
the hood controls.
6.4cm
6.35cm
7.7cm
7.6cm
Bracket position without spacers
Bracket position
with 1 spacer
Bracket position
with 2 spacers
6.35cm
3
Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
Install Range Hood
I
WARNING
EXCESSIVE WEIGHT HAZARD.
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
RANGE HOOD.FAILURE TO DO SO CAN RESULT IN BACK OR
OTHER INJURY.
1
Remove the polyurethane piece that comes inside the hood.
2
Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19
mm screws into the hood canopy assembly and tighten all
(8) mounting screws.
A
B
C
A. Cabinet
B. Hood liner canopy
assembly
C. Screws - 4.2 x 19
mm (8)
3
Remove the protective from the metal grease filters and
pull them out from the face panel.
4
Pull out the lamps connector cables
5
Attach the mounting brackets to the inside of the hood
as shown in the picture, using four 3.5 x 6.5 mm screws.
Summary of Contents for EUM628SS
Page 40: ......
