ELICA ALTAIR GRAY/F/50, Instruction On Mounting And Use Manual, Page: 37 / 148

37
(signal off).
Repeat the operation if you want to reactivate the signal.
LED
L1 will switch from flashing red (signal off) to
remaining lit (signal on).
Filter saturation warning reset
With the hood off, press the keys T1 and T2 simultaneously
for at least 5 seconds. The LED L1 will stop signalling
saturation.
Repeat the operation in case of simultaneous warnings of
both filters.
Pairing the remote control
Once the remote control has been successfully paired both
LEDs light up in several colours in sequence.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS . Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Fig. 28-29-30
Traps cooking grease particles.
This must be cleaned at least once a month (or when the filter
saturation indication system - envisaged on the model in
possession - indicates this necessity), using non-aggressive
detergents, in a dishwasher, which must be set to a low
temperature and a short cycle (Tmax: 70°C).
When washed in a dishwasher, metal parts may discolour
slightly.
The filter must be dried in an oven for one hour at a max
temperature of 100°C; if the filter is still moist, repeat the
operation.
Replace the filter at least every 2 years.
Attention! After having performed maintenance on the filter,
FIRST install the grease filter in the specific container and
THEN the charcoal filter. The latter can be recognised as it is
sealed inside a braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Charcoal filter (filter version only)
Fig. 28-29-30
It absorbs unpleasant odors caused by cooking.
Attention!
The active charcoal filter can be recognised as it is
sealed inside a braiding. Perform disassembly, maintenance
and cleaning operations of the filter, managing it with the
utmost care to avoid damaging or opening the braiding.
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
the model in possession – indicates this necessity) using hot
water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Attention! After having performed maintenance on the filter,
FIRST install the grease filter in the specific container and
THEN the charcoal filter. The latter can be recognised as it is
sealed inside a braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Replacing lamps
Fig. 29
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
To replace lights, contact authorised spare part center.