Eli User Guide
Installing Eli
Eli can be setup in a few easy steps:
1. Connect your PCs to Eli and connect Eli to either your telephone jack or your router.
2. Configure your PCs to connect to Eli by entering the information provided to you by your ISP
to connect to the Internet.
3. Once connected to the Internet, configure your personal security settings for Eli.
1. Hook up Eli.
a) To replace your DSL modem with Eli: ´
i. Make sure the switch WAN SW is set to ADSL.
ii. Connect the RJ-11 telephone cable from your phone jack to the WAN port labeled
ADSL on Eli’s rear panel.
To connect Eli to a cable modem:
i. Make sure the switch WAN SW is set to Eth.
ii. Connect Eli to your cable modem using a straight RJ-45 network cable between the
WAN port labeled Eth/ADSL and to your cable modem.
To connect Eli directly to a router:
iii. Make sure the switch WAN SW is set to Eth.
iv. Connect Eli directly to your router using a straight RJ-45 network cable between the
WAN port labeled Eth/ADSL and to your router.
b) Connect one end of a straight RJ-45 network cable to one of the 4 LAN ports on the back of
Eli and the other end to the network adapter port of your PC.
c) If you want to connect more than one PC, repeat this step for your other PCs. You can
connect up to 4 PCs to the internal switch on Eli.
d) Connect the power adapter to the Power port on the rear panel of Eli, then plug the power
adapter into a power outlet.
e) Switch on Eli.
f) The
Power LED on the front panel will light up green as soon as the power is switched on.
Eli’s hardware installation is now complete!
You can now continue by setting up your Internet connection for Eli.
TEST.doc
16 March 2005
5
