22
Installation
Teach-in of the limit position “Extended” (red button):
2. Traverse the drive to the desired position.
3.
Save the position by briefly pressing the red button.
9
The red button lights up.
The limit position “Extended” is taught in.
4. The red button goes out, when the piston is moved away from the limit posi-
tion.
Teach-in of the limit position “Retracted” (green button):
5. Traverse the drive to the desired position.
6.
Save the position by briefly pressing the green button.
9
The green button lights up.
The limit position “Retracted” is taught in.
7. The green button goes out, when the piston is moved away from the limit
position.
Precision adjustment of the limit positions:
A precision adjustment of the limit positions is not possible until both limit posi-
tions have been taught in. The precision adjustment can be performed or cor-
rected several times. The drive must be located in the relevant limit position.
1. Traverse the device to the corresponding limit position until the red or green
button lights up.
2. To adjust the exact position of the limit position press the corresponding but-
ton once or several times.
Red button:
increases the traversing range
Green button:
decreases the traversing range
Each press of the button represents approximately 0.3 mm.
Press the button a maximum of eight times. The position then has to be reap-
proached.
3. Approach the position again to check the precision adjustment.
