elero AstroTec-915ac, Operating Instructions Manual

Page: 19 / 20

USA-35 USA-36
US
A
Technical data/Battery replacement/
Cleaning
Nominal voltage 3 V DC
Battery type 2 x LR 03 (AAA)
System of protection IP 20
Permissible ambient temperature 0 to +55 °C
Type of installation Wall-mounted
Radio frequency 915,3 MHz
Technical data
Battery replacement
1. Remove the batteries.
2. Insert the new batteries
properly .
LR03 (AAA)
LR03 (AAA)
--
--
Note : The batteries must be
replaced within one
minute . When changing
the batteries, ensure
that no buttons are
pressed.
Cleaning
Clean the device with a damp cloth only.
Do not use a cleansing agent since this could damage the plastic.
Programming
FUNCTION (only when the operating device is disconnected, only for
qualified electricians)
ROLLER SHUTTER/BLIND, DRIVE CONTROLLER/ GROUP CONTROLLER,
RUNNING TIME
(Selection of shutter/blind, selection of the drive controller/ group
controller, running time of the roller shutter/blind)
+
O K
FUNCTION
ROLLER SHUTTER/
BLIND
OK
OK OK
+/– +/– +/–
DRIVE CONTROLLER/
GROUP CONTROLLER
RUNNING
TIME
Operating
mode
OK
1. Press the MENU button.
2. To select the FUNCTION menu, press the
+ button until FUNCTION appears.
3. Confirm by pressing OK . ROLLER SHUTTER/BLIND will appear.
4. You can select either roller shutter or blind using the +/- button.
5. Confirm by pressing OK . RUNNING TIME will appear.
6. You can set the required running time using the +/- button.
(Default setting: 120 seconds).
7. Confirm by pressing OK . EXPERT MODE ON/OFF will appear.
8. You can make the setting you require using the +/- button.
9. Confirm your selection by pressing OK . INITIAL OPERATION will
appear.
10. Confirm by pressing OK .
11. Press the MENU button to switch to operating mode.