EN-8
EN
Safety instructions for radio operation
EN-7
Mounting of the wall bracket
C A U T I O N !
Observe the following safety instructions for radio
operation!
Only use radio systems if they are approved and
can be operated without interference.
• Please note that radio systems must
not
be operated
in areas with an increased risk of interference
(e.g. hospitals, airports, ....).
• The remote control is only approved for devices and
systems for which any malfunction of the transmitter
or receiver would not result in a risk for persons,
animals or property, or if such a risk is covered by
other safety equipment.
• The operator has no protection whatsoever from
interferences by other radio emitters and local termi-
nals (e.g. also from radio systems), that are normally
used on the same frequency range.
• The range of the radio signal is limited by the
government and the built environment.
Mounting of the wall bracket
1. Use the drilling template on the inside of the packing box.
2. Remove the cover from the box.
3. Fix the drilling template to the wall.
4. Drill the holes in the wall.
5. Remove the drilling template.
6. Push the bracket upper and lower parts to separate them.
7. Fix the bracket lower part onto the wall using the screws and
dowels provided.
8. Push the bracket upper part from above onto the bracket lower
part until it is locked into place.
4,5
10
,5
24,
75
4,5
4,5
13
,5
N O T I C E !
The wall bracket has to be fixed so that the drill
holes don’t touch any electrical lines.
Check this before installation.
Bracket upper part
Bracket lower part
