-10-
WIRE BINDING POSTS AND 317, 337
Solder the wires from the board to the binding posts, as shown in Figure K.
3” Blue wire from (G) on the PC board; To the Yellow post (–1.5 - 15V).
3” Orange wire from (H) on the PC board; To the Black post (common).
6” Blue wire from (D) on the PC board; To the Black
post (common).
6” Red wire from (C) on the PC board; To the
Red post (+5V 3A).
3” Red wire from (I) on the PC board; To the Red post (+1.5 - 15V).
Place the heat sink with ICs and
transistor in the position, as shown in
Figure K. Insert the wires from the PC
board, through the rectangular hole in
the chassis, to the ICs and solder into
place.
Tin the leads. Form the end of the wires
into a tight loop, for easy, tight
connection to leads, before you apply
solder.
Figure K
LM-317
LM-337
I
H G
D
C
Black
Post
6” Red
6” Blue
3” Red
Red
Post
Black
Post
Yellow
Post
3” Orange
3” Blue
3 1/2” Red wire (W) from PC board; To
middle lead of LM-317.
3 1/2” Orange wire (S) from PC
board; To left lead of LM-317.
3 1/2” Blue wire (U) from PC board; To
right lead of LM-317.
3” Red wire (R) from PC board; To
middle lead of LM-337.
3” Blue wire (T) from PC board; To left
lead of LM-337.
3” Orange wire (V) from PC board; To
right lead of LM-337.
After wiring the ICs, be sure that none
of the leads touch each other and
cause a short.
Red
Post