-9-
Solder the black transformer wire (B), as shown in Figure J to lug 2 on the rocker switch.
Twist the black transformer wire (A) and the ribbed or flat line cord wire together. Solder the two wires to
lug 1 on the rocker switch, as shown in Figure J.
Slide the 3/4” diameter shrink tubing over the switch and shrink into place.
Solder the two red transformer wires to the holes marked T2 on the PC board.
Solder the black transformer wire to the hole marked CT1 on the PC board.
Solder the two blue transformer wires to the holes marked T1 on the PC board.
Slowly push the PC board stand-offs into the four holes on the bottom of the chassis. Push the PC board
down into place.
WIRING LINE CORD, FUSE, TRANSFORMER AND SWITCH
Figure J
PC Board
Chassis
Side Lug
End Lug
Smooth Line Cord
Flat or Ribbed Line Cord
1 2
3
(A) Black
Red
Red
2” Tubing
Yellow
Yellow
Ribbed
Line Cord
Install the line cord ground lug to the chassis
using a 6-32 x 3/8” screw and a 6-32 large
nut in the location shown in Figure J.
Strip the insulation off of both ends of the
6” red 20 ga. wire to expose 1/4” of bare
wire. Solder one end of the wire to lug 3 on
the rocker switch, as shown in Figure J.
Slip the 2” section of shrink tubing over the
other end of the 6” 20 ga. red wire and the
smooth or round line cord wire. Solder the
line cord wire to the end lug on the fuse
holder, as shown in Figure J. Solder the 6”
20 ga. red wire to the side lug on the fuse
holder. Slide the shrink tubing over the fuse
holder, covering the two lugs. You may use
a hair dryer, heat gun (at lowest setting or
you will melt the tubing) or the heat
emitting from your soldering iron.
CAUTION: DO NOT touch any wires or
tubing with the iron.
Slip the 6” strip of red wire (leading from the
side lug of the fuse holder), the (A) and (B)
black transformer wire, and the ribbed line
cord wire through the 3/4” diameter piece of
shrink tubing (as shown in Figure J).
Blue
Black
Blue
(B) Black
6” 20 Ga.
Red
J
K
T2
T2
T1
CT1
T1
W
V
U
3/4” Shrink
Tubing
6-32 x 3/8” Screw
6-32 Large Nut