Element4 Modore 100 H, User And Installation Manual

Page: 3 / 44

3
a registered gas installer be employed for this
task. The engineer will provide you with informa-
tion about the safety limits of the installation and
should fix a notice plate in a place where it can
be readily seen.
This appliance is designed as an efficient heating
device and consequently all body parts become
very hot in use. Except for the control knob and
control access door, which are designed to stay
cool, all other parts are working surfaces and
should not be touched.
The glass and frame on this appliance acts as
a fireguard conforming to BS: 1945 – 1971 and
satisfies the Heating Appliance (Fireguards)
regulations 1991. No part of the window or frame
should be permanently removed.
It does not give
protection for young children aged or infirm ,
extra guarding(conforming to BS8423: 2002)
should be considered so the special hazards that
exist in nurseries and other places where there
are young children, aged or infirm persons are
minimized.
Bearing in mind that the heat given off by this
appliance may affect articles placed close to it,
curtains should not be placed within 30cm.
The appliance is not designed as a dryer. It is not
therefore recommended that the appliance be
used in such a manner. Do not place any articles
within 30cm of this appliance as this may result
in damage to the articles.
The installation must be carried out in accordance
with the following regulations:
ment of the Environment, the Building Standards
(Scotland) (Consolidation) Regulations issued by
the Scottish Development Department.
GENERAL INFORMATION
Important Safety Notice
This appliance has a ceramic Fire-bed arrange-
ment; this contains Refractory Ceramic Fibres,
which are man-made vitreous silicate fibres. Ex-
cessive exposure to these materials can cause
irritation to eyes, skin and respiratory organs.
Hence we recommend that when handling these
materials the release of dust should be kept to
a minimum. During installation and servicing we
recommend that a HEPA filtered vacuum be used
to remove any dust and soot in and around the
fire. If any of the ceramic fire-bed components
need to be replaced we recommend that the re-
moved parts be sealed in a heavy-duty polythene
bag, and be labelled as RCF waste. RCF is not
“Hazardous waste” and can be disposed of at a
licensed tipping site for the disposal of industrial
waste.
The appliance incorporates a permanent pilot.
This is located on the front of the burner, and
must not be adjusted by the installer. This system
must not be put out of operation, and if any parts
require changing, only original manufacturer parts
shall be used.
This appliance is designed to be used either Natu-
ral or LPG gas however, each individual appliance
is only capable of running off the type of gas
specified at the time of purchase. It is important
to note that once a type of gas has been speci-
fied the stove cannot run off any other type. The
type of gas that your stove is capable of burning
is stated on the data information panel.
This appliance has been designed, tested and
approved to meet standards in place for prod-
uct use, performance and safety. Installation of
your appliance must comply with current build-
ing regulations. It is therefore recommend that