51
Element4 Gas Fireplaces Rev# 03242020
European
Home
.com
APPENDIX TWO
Transmitter batteries low.
Replace transmitter batteries. Quality
alkaline recommended.
Receiver batteries low.
Test the batteries. replace if necessary.
Quality 1.5V AA alkaline recommended.
Note: Do NOT connect an AC adapter when
using receiver batteries.
Check that transmitter and receiver are
synchronized.
Reset system, see the installation manual
or the label on the receiver.
One long beep indicates the wiring is
incorrect or the code learning sequence
has failed.
Transmitter distance is limited.
Straighten the antenna.
Replace the receiver.
Defective AC adapter
Replace the AC adapter.
Damaged wiring
Inspect/test all wiring and connections.
2nd thermocouple is producing
electricity.
Wait for 2nd thermocouple to cool down
(3-5 minutes)
FUNCTION
POSSIBLE CAUSE
REMEDY
Yes
No
A.
Press the ON button
to start ignition
sequence. Beep will
occur each
second.
(continued)
TROUBLESHOOTING FLOW CHART
Receiver batteries low. Test the batteries, replace if necessary.
Quality 1.5V AA alkaline recommended.
Impulse magnet not
operating properly.
Replace gas valve.
B.
Magnet unit is
energized thus pro-
ducing an obvious
latching sound.
No beep
3 short beeps
1 long beep
8-wire cable is off or
not operating
properly.
Confirm proper operation of the 8-wire
cable.
SW-cable
disconnected.
Confirm proper connection/operation of
the SW-cable.
Motor not operating
properly.
Replace gas valve.
Micro switch not
operating properly.
Replace gas valve.
2nd thermocouple
not connected
Confirm integrity of 2nd thermocouple and
connection.
No
No
No
Yes
I:\DEPARTMENTS\Technical Support\Troubleshooting\Guides\20181205_Troubleshooting Flow Chart_E4_8btn Edition.indd
