33
OPERATING the FIREPLACE
Element4 Gas Fireplaces
European
Home
.com
BEFORE THE FIRST FIRE
1. Make certain that all construction materials have been removed from inside and around the fireplace and the fireplace has
been cleaned of any construction dust. Clean the glass BEFORE and AFTER the first fire.
2. ENSURE THAT ALL WIRING AND CABLES ARE CLEAR OF ALL OF THE FANS!
3. Confirm that the gas valve is properly connected and bled by a certified gas technician or plumber.
4. Check the gas supply for leaks and proper pressure. Refer to the table in “Appliance Ratings” section.
5. Check that the venting is unobstructed and in proper working condition.
6.
6. PROPERLY PLACE, CLAMP, AND SEAL THE GLASS PANELS.
PROPERLY PLACE, CLAMP, AND SEAL THE GLASS PANELS.
7. Ensure the receiver is plugged in with AC Adapter
OR
Batteries -
NOT BOTH
.
8. Place the two (2) AAA batteries into the remote control and confirm that it will communicate with the receiver by pressing
the
ON
/
OFF
button. If necessary pair the remote and receiver (see below).
9. Follow
USING THE REMOTE CONTROL ELECTRONIC IGNITION SEQUENCE
to setup and use remote.
Note!
For normal operation the
MANUAL
knob on the gas valve cannot be in the
MAN
position; it must be fully in the
ON
position.
This knob is AUTOMATIC and will turn
to OFF when the fireplace is turned
off and to ON when the fireplace is
turned on.
MANUAL
KNOB IN
ON
POSITION
MAIN VALVE
KNOB
IN
ON
POSITION
After removing the black plastic plug, turn the screw
counterclockwise to lower the pressure and clockwise
to raise the pressure. This adjustment is required for fuel
conversions.
PRESSURE REGULATOR
SCREW
GAS VALVE KNOBS
PAIRING THE REMOTE AND RECEIVER
(System Reset)
1. Press and hold the receiver reset button using a small, long tool until you
hear the second of two beeps. After the second beep release the reset
button.
2. Press and hold the button on the remote until you hear the second of two
beeps. Release the button.
If you hear one long beep, this indicates the pairing sequence has failed or the wiring
is incorrect. Re-synch the remote.
RESET
BUTTON
Figure 50
Figure 51
Summary of Contents for Lucius 140 GSB
Page 59: ......
