APPENDICES
18
A FIRST AID FOR MALFUNCTION
Below you will find an overview of the possible cause and
solution in the event of a failure.
Problem
Possible Cause
Solution
A No transmission
(motor will not
run)
1 Batteries in the receiver empty
Replace the batteries (4x 1.5V AA)
2 Batteries hand remote empty
Replace the batteries (2x 1.5V AAA)
3 6V-adapter defective
Check the adapter
Replace the adapter if necessary
4 Hand transmitter not linked to the receiver
Connect the hand transmitter to the receiver
Press and hold the reset button (see
Figure A.1
) until you hear
two beeps. Aft er the second longer tone, release the reset
button. Press within 20 sec. on the down arrow on the hand
transmitter
Two short beeps confirm that the code has been set.
Tip:
For this action a video is available on our youtube channel
B Receiver does not
receive a signal
1 Receiver defective
Replace receiver
2 Bend pin connection on the receiver
Bend the pen straight again (See
Figure A.2
)
3 Hand transmitter defective
Replace the hand transmitter (see
Figure A.3
)
4 No or bad reception. The receiver is in a metal
box! This disturbs the reception.
Change the position of the antenna (See
Figure A.4
)
C No ignition;
no beep
1 Receiver defective
Reset the receiver (See
K
1)
If necessary, replace the receiver
D No ignition;
receiver gives a
five-second beep
1 Loose contact in the thermocouple circuit / wiring
2nd thermocouple
Check plug connections
Repair the wiring if necessary
2 Receiver defective
Replace receiver
3 Magnetic coil defective
Replace gas block / or only coil coil
4 Bent pin connection on the receiver
See
B
2
5 Thermocouple broken
Check the thermocouple at the bottom of the pilot burner if
necessary. fracture.
Replace the thermocouple if necessary
E
Ignition stops aft er
1 spark
1 Mass on the gas block not OK
•
Remove the 20mm Torx screw (See
Figure A.5
)
•
File or scrape the surface thoroughly
•
Reinstall the Screw and tighten it securely
Tip:
For this action a video is available on our youtube channel
F
No pilot flame but
there is an ignition
1 No gas
Check / measure gas inlet pressure
2 Air in the gas line
Venting the gas line can be done via test point A (
Figure A.6
)
Tip:
For this action a video is available on our youtube channel
3 Pilot flame blocked
Check pilot burner (
Figure A.7
)
4 Thermocouple wiring is incorrect
Check the wiring on the interrupter (See
Fig. A.8
)
Check the wiring on the receiver (See
Fig. A.9
)
