24
25
TROUBLESHOOTING
FCC NOTES
Note: When there is a problem in VGA mode ( only when VGA mode is applied).
PROBLEM
POSSIBLE SOLUTIONS
The signal is out of range
• Adjust resolution, horizontal or vertical
frequency.
• Check whether the signal cable is connected or
loose.
• Check the input source.
Vertical bar or strip on the
background, horizontal noise
and incorrect position
• Set the auto configure or adjust clock, phase, or
H/V position.
Screen color is unstable or is a
single color
• Check the signal cable.
• Reinstall the PC video card.
Maintenance
Early malfunction can be prevented. Careful and regular cleaning can extend
the amount of time you will have with your new TV. Be sure to turn the power off
and unplug the power cord before you begin any cleaning.
Clean the screen
A great tip to dust off your screen: wet a soft cloth in a mixture of lukewarm
water and a little fabric softener or dish washing detergent. Wring the cloth until
it’s almost dry, and then use to wipe the screen.
Make sure the excess water is off the screen, then let air-dry before you turn on
the TV.
Cleaning the cabinet
To remove dirt or dust, wipe the cabinet with a soft, dry, line-free cloth. Please
be sure not to use a wet cloth.
SPECIFICATIONS
Panel Size
23.6 inches diagonally
Display Type
LED
Panel Technology
TFT
Panel 60 Hz Vs. 120 Hz
60 Hz
Display Resolution
1080P
HDMI & Component Support
Up to 1080P
Panel Resolution
1920 x 1080
Aspect Ratio
16:9
Dynamic Contrast Ratio-Panel
1000:1
Brightness (Centre Typ.) Cd/M²
220
Response Time (G To G)
5 ms
Lamp Life (Typ. Hours)
50000 hours
Horizontal Viewing Angle (At CR>20)
140
Vertical Viewing Angle (At CR>20)
130
TV System
ATSC/NTSC
Channel Range
VHF/UHF
Design and specifications are subjects to change without prior notice.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed or used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. Where shielded
interface cables have been provided with the product or specified additional components
or accessories elsewhere defined to be used with the installation of the product, they must
be used in order to ensure compliance with FCC regulation.
