E-6
ElektroPhysik
Preparing / Instrument settings
6.
Switch on the control unit (red button). A short
bleep indicates that the instrument is ready for
operation. If no bleep sounds, the storage
batteries should be recharged or replaced by new
ones.
Safty note:
As soon as the earth cable is disconnected from the
instrument, the feed of the high voltage probe will be
interrupted.
4. Preparing the test object
Make sure the surface of the test object is dry and clean.
5. Selection of the test electrode
For surfaces susceptible to scratches we recommend
to use the silicon rubber electrode. For uneven surfaces,
the metal sweeper electrode is recommended. Special
electrodes available upon request
6.
Instrument settings
1.
Swtich the gauge on. Press Menu/Enter key.
The following message appears:
Current readings
XXX...
Press Menu/Enter to go to the Main menu (your
selection is shaded on display).
2.
Using Arrow-keys the following parameters can
be selected and adjusted according to your
requirements.
• Test parameters
• Sensitivity
• Limit for pores
