Resistance Welder MULTISPOT MI-90 T
Transport, packaging, storage
16
3.4 Acceptance after shipping
Check packing units immediately after delivery. Check for integrity, missing pieces and damage.
If you detect any external shipping damage, proceed as follows:
Do not accept delivery. Or accept under reserve.
Report damage on carrier's shipping papers or delivery ticket.
Initiate complaint procedure.
NOTE
Be sure to register a complaint as soon as a defect has been detected. Claims for damages
may be brought forward only within the deadlines set for complaints.
3.5 Handling
3.5.1 Forklift
Fig. 6: Using a forklift
Packing units on pallets may be handled with a forklift, as long as
the following conditions are fulfilled:
The forklift must be certified for the weight of the packing unit at
hand.
The operator must have a licence to drive forklift.
Packing units may have very high centres of gravity. Make
absolutely sure they cannot tip over.
NOTE
Keep the original pallet in case of any further
transport needs (return of goods, further transport).
3.5.2
Moving equipment to the site
There is a danger of tipping and toppling of the device because of its centre of gravity
CAUTION ! Tipping and toppling may cause damage to property.
This equipment's centre of gravity is relatively high. In the event the wheels jam and/or block
(due to an obstacle or transverse pull, for instance), there is a danger the equipment tips over.
Therefore:
– Keep potential obstacles out of the work area.
There is a danger the equipment rolls away because the wheels must not be blocked due to the
tipping and toppling hazard.
CAUTION ! Equipment rolling away may cause damage to property.
The wheels of the equipment must not be blocked because this would cause a tipping and
toppling hazard.
On the other side, though, this detail causes and increases the danger the equipment rolls
away. Therefore:
– Be sure to operate this equipment only on a flat and even floor.
– Proceed with care when moving this equipment.
