KERCOMET 170
und
210, MULTIMIG 150
Setup and transport
8
10 Setup and transport
Danger of injury due to the de-
vice falling over and crashing!
When transporting using mechani-
cal lifting equipment (e.g. crane,
etc.), only the hoisting points shown
here may be used. Use suitable
load-carrying equipment.
Each lifting point must be loaded
separately. Do
NOT
, for example
put one load strap through both
handles, as this could lead them to
be pulled together and cause
breakage!
Do not use a fork-lift truck or similar
device to lift the machine by its
housing.
Remove the gas cylinder from the
welding machine before transpor-
tation .
The machine must be transported
or set up only on firm, level sur-
faces. The maximum admissible
angle of inclination for setting up or
transporting is 10°.
Fig. 2:
Lifting point for 4-point hoisting
