35
34
LANGUAGE SELECTION
This allows the conversion of all the communications made by the machine into Italian
or English or French or Spanish or German.
TIME AND DATE SETTING
This is used to set the minutes, hours, days, months and year for correct night cycle
management and dating of statistical data.
NIGHT CYCLE PROGRAMMING
The night cycle programming is obtained by setting a start time and an end time.
See chapter “A USE”, paragraph 2.
BREWING TEMPERATURE SETTING
This allows the brewing temperature to be varied according user requirements, the
blend being used or environmental conditions, with a view to obtaining the best
“quality in the cup”.
This is done by setting the required increase (or decrease) of the temperature in
relation to the standard brewing temperature, measured in centigrade degrees (°C).
The standard brewing temperature is that programmed by the manufacturer and is
the same for all produced pieces of this model.
After varying the brewing temperature, make at least three espresso coffee per
dispensing group to enable the new temperature to stabilize itself.
See chapter “C DESCRIPTION OF THE APPLIANCE”, paragraphs 2 and 6.
CRONO SETUP
It allows to set ON or OFF the displaying of the delivery time and of the coffee volume in
the cup.
See chapter “A USE “, paragraph 7.
SCHEDULED MAINTAINANCE ALERTS RESET
If a scheduled maintenance program has been activated (see paragraph 3 “SPECIAL
PROGRAMMING”), this function lets you reset the maintenance alert once the
espresso coffee machine has been serviced.
The alert can be reset by entering the reset code known to the technician.
COFFEE PRODUCTION DISPLAY AND RESET
The system records the number of cups of coffee dispensed by each button for each
group. Each dispensing activated by double buttons corresponds to two cups of
coffee.
These data can be zero-set by entering the Reset Code known to the technician.
1.1
1.2
1.3
1.4
BREWING PRESSURE ADJUSTING
With a view to obtaining the best “quality in the cup”, brewing pressure may be adjusted.
Recommended pressure is between 0.8 MPa (8 bar) and 0.9 MPa (9 bar).
Disassemble the frontal lower steel panel on the machine’s work side, unscrewing the five
screws that fix it in place.
Behind it lies the pump with its pressure regulator, which can be adjusted with a screwdriver.
Pressing the “ENTER” pushbutton, at a certain moment will be displayed the water
supply pressure: dispense a coffee on the right group by pressing the button marked
by symbol : the pressure displayed will change in brewing pressure: proceed adjusting
the pump.
SPECIAL PROGRAMMING
This allows the personalization of certain machine functions according to important
servicing, marketing or individual end Customer requirements.
Special Programming is the exclusive responsibility of the dealer’s specialized technician
who will have been specifically trained by ELEKTRA to do so.
Special Programming should be carried out on the dealer’s premises prior to installation.
It is carried out via PC by connecting a special cable to the machine’s electronic control
unit and the ELEKTRA program.
These functions are as follows:
- Setting of a scheduled maintenance program.
- Activation of start of dispensing only upon reaching the ideal brewing temperature.
- Activation of brewing satisfactory control according to Italian espresso standards.
- Personalization of maximum coffee dispensing time.
- Personalization of the maximum heating element “on” time.
- Personalization of the reset code for the scheduled maintenance call, coffee
production and water consumption.
- Saving and printing of all machine configuration data.
- Saving and printing of all machine cumulative historical data.
1.6
1.7
1.5
2
3
WATER CONSUMPTION DISPLAY AND RESET
The system records the volume of water consumed.
These data can be zero-set by entering the Reset Code known to the technician.
1.8
