Elekitsorparts Store Item Name: FAA-450_EU1KY_Antenna Analyzer
Item No.: H10010
Document Type: Manual
15
Picture 25: USB HS cardrdr
Please following the instructions below to access the files on the TF card:
a. Turn on FAA-450 and make sure it is on the main screen.
b. Connect FAA-450 to your PC via USB-HS port by the supplied micro-USB cable
c. Tap ‘USB HS cardrdr’ to get into the USB storage access mode.
d. When it is in USB storage access mode, wait about 30s until your PC finds a new hardware. The driver will be installed,
and a new disk will be added in your disk list in the windows explorer. See the picture below:
e. When finished, eject this new disk just as the normal flash disk does in your PC. Or tap ‘Exit(Reset device)’ on FAA-450,
this will eject the emulated disk automatically and reboot the analyzer.
Picture 26: A new disk is found and labeled ANALYZER
Picture 27: The AA folder contains all of the sub-folders and files used by FAA-450
The analyzer’s configuration file is saved in the CONFIG folder as CONFIG.BIN. The OSL calibration files are saved in OSL
folder named as A.OSL or B.OSL and ERRCORR.OSL. The screen shot pictures are contained in SNAPSHOT folder as PNG
format, also the logged plot file in S1P format.
7.14 Time Domain
Time Domain mode detects the reflected RF signal in the coax and measures the distance from the coax feed point to the
reflection point. It is useful as you can determine the broken point of your cable, or the length of your coax if there is no broken
point. Please keep in mind that all of the measurement results are based on the preset TDR Velocity Factor (0.66 by default),
and you can access TDR setting from the configuration sub-menu.
To get into the TDR mode, tap ‘Time Domain’ on the main screen, then it shows:
